EDIT - Have moved the zip file to the template library when I found that shortly after making my original post; apologies for any confusion caused.
Here is my very first model setup for the Taranis, which I’m using on balsa Zlin 50 from Hobbyking. This setup should work great on any aerobatic electric model with a two servo wing (i.e Wot 4-e, Acrowot Foam-e, Max Thrust Riot, ST Models MX2 etc).
Features (v2 additions in bold):
- Simplified mixer schema (flap and snapflap fns moved to high mixes; extensive use of GVARs).
- 3 flight modes on switch SE (Acro, Takeoff and Landing).
- Partial flap deployed for Takeoff; full flap for Landing. Transitions slowed over 2 seconds.
- Triple rates on switch SA, active only in Acro mode (Takeoff and Landing use medium rates).
- Snapflap (elevator to flap) mixing by default in Acro and Takeoff flight phases.
- Snapflap volume adjustment on pot S1.
- Snapflap suppression on switch SG.
- Throttle kill on switch SF with optional visual confirmation (deflects elevator 45 degrees when throttle deactivated) and pre-flight check reminder; now implemented via mixers rather than a custom function.
- Custom throttle curve to remove non-linear ESC response (will need to be tuned for each model).
- “Nagging Nora” gives power-up announcement in Takeoff and Landing modes at low throttle settings (reminder to avoid throttle shut landings; I am mainly a glider pilot!)
- Eagletree Guardian gyro control on switch SD (2D mode, 3D mode and off)
- Flight countdown timer (reset by throttle kill on switch SF) and total model time timer.
- Flight time remaining called out by short press of switch SH.
- RSSI value called out by long press of switch SH.
- Volume adjustable via pot S2.
- Model name announcement on start-up/selection.
EEPE, documentation and sound files in Template library
Matt