Nose Wheel Steringamount based on Throttle

[ripcurl777]

Hi all,

im using openTX since 1 Year and have several Models programmed. Also complex Mixing but for this i cant find a solution.

I have a Cessna 180 200mm with a indipendent Nose Wheel stering servo. So now i want to do a mix in combination with throttle.
(Same like cars have for Steering and Speed).

So, as more throttle i have, as slower (weight) i want to have reaction to my Nose Wheel steering servo.

For Example:

Throttle Steering Wheel Servo
0% 100%
10% 90%
20% 80%
30% 70%

and so on...

it tried with custom swichtches and curves but no effort.

i imagine this like a kind of D/R based on the amount of throttle... but cant get it to the point.

Any ideas?

thanks a lot

[MikeB]

Add a mix line to your steering servo output like (note a MULTIPLY multiplex mix):

* -50% THR Offset(-100%)

Mike.

[gohsthb]

If you did want to keep some steering at full throttle you could use a curve:
+100% RUD
*100% THR Curve(C1)

Then curve C1 is 100 75 50 25 0. Set up like this it will do the same thing Mike's above does. If you start raising the right hand side of the curve however then you can still have some steering. You can keep 10% of the steering by making the curve like this 100 77 55 32 10. I just made the curve linear by moving the points between the 100 and 10.
-Gohst