Rudder and Ailerons are Switched

Post Reply
bobv13
Posts: 2
Joined: Sat Jun 20, 2020 1:06 am
Country: -

Rudder and Ailerons are Switched

Post by bobv13 »

Firsrt... I'm a nube to Opentx, Jumper transmitters and Lemon Stabilizer receivers however I believe opentx may solve my problem. My rudder and ailerons are not responding as expected.

After setting the model on the Jumper with multi dsm subtype x 11ms I bound the lemon receiver with the Jumper Xmitter. Everything ok.
Next the switches 4&5 were flipped on the lemon to indicate a normal 4 channel setup.

Powered it all up and at first everything seem fine. BUT when I checked the channel assignments there was a problem. The rudder moved when the ailerons should have ...meaning when I mover the right hand controller left and right the rudder moved. The opposite occurred when I moved the left controller.

I hopped to correct the problem by switching the servo connections, and it did however ... now the auto correction for the stabilizer is now incorrect.

I'm hopping I can switch connect the rervos normally and make a change on the Jumper transmitter. Can transmitter channels be reassigned?

Any help will be appreciated
Thanks BobV

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Rudder and Ailerons are Switched

Post by Kilrah »

Reorder the channels on the mixer page.
bobv13
Posts: 2
Joined: Sat Jun 20, 2020 1:06 am
Country: -

Re: Rudder and Ailerons are Switched

Post by bobv13 »

Thanks

Post Reply

Return to “openTx model setup”