Want output to read 100% even though I modified min/max

Post Reply
xoexoe
Posts: 2
Joined: Wed Jul 03, 2019 12:05 am
Country: -

Want output to read 100% even though I modified min/max

Post by xoexoe » Wed Jul 03, 2019 12:16 am

On my output page I had to change the the min/max of all of my channels to match my flight controller extremes. But now my channel log shows something like -83% when I’m in brittle hold. I want the channel output in this case to be expressed as -100%, even though I decreased (increased?) the min value.

Is there a way to do this? I really like the channel monitor but I want it to obey the modified extremes of my outputs, not look at the default extremes.

X10S with OpenTX 2.2.3
Last edited by xoexoe on Wed Jul 03, 2019 12:16 am, edited 1 time in total.


User avatar
Kilrah
Posts: 10240
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Want output to read 100% even though I modified min/max

Post by Kilrah » Wed Jul 03, 2019 7:32 am

No, the monitor and log are about the exact value sent out.

You can look at the top bar on the monitor to see what goes into the "outputs" stage.

xoexoe
Posts: 2
Joined: Wed Jul 03, 2019 12:05 am
Country: -

Re: Want output to read 100% even though I modified min/max

Post by xoexoe » Wed Jul 03, 2019 1:56 pm

Thank you


Post Reply

Return to “openTx model setup”