Adjusting flap to elevator compensation during flight.

Post Reply
ThompsonJim
Posts: 70
Joined: Thu Aug 30, 2018 10:42 pm
Country: Australia

Adjusting flap to elevator compensation during flight.

Post by ThompsonJim » Tue May 14, 2019 6:10 am

I am in the practice of selecting the flap to elevator mix before flying a flapped glider or power plane, in my formerly used Futaba 8U.
I assume that this is similarly possible using my new Taranis 9XD Plus. Is the best practice to select the window I show in the attached screenshot before launching? Then adjusting the weight after testing the Flaps at a minimum altitude?
Is this safe to do?

Jim.
Attachments
elevator compensation window.png


ThompsonJim
Posts: 70
Joined: Thu Aug 30, 2018 10:42 pm
Country: Australia

Re: Adjusting flap to elevator compensation during flight.

Post by ThompsonJim » Mon Jun 03, 2019 12:45 pm

I have found an answer to my own question.
The main "volume control" mix is described here: http://rc-soar.com/opentx/setups/adjuster/adjuster.htm

I will put up a screenshot of my final mix tomorrow.
It works good...........controlled by S1 rotary knob.

Post Reply

Return to “openTx model setup”