XJT Mode - switch on module case or in model settings
Posted: Fri Feb 09, 2018 10:39 pm
When setting model, we can bind receiver and transmitter from model setup panel. There are also other transmitter settings - for example mode.
And here is a question: when I want to bind particular type receiver (let it be D8 mode as example and FrSky XJT module), should I set mode on transmitter case by setting switch 1 on and switch 2 off, or just in this menu I should chose D8 mode and that will be enough? Or maybe I should set D8 mode both using switches on case and in openTx menu?
What will happen if I set different values via switches and this menu? Which settings is more important? Any of them, or it won't work with different modes set?
And here is a question: when I want to bind particular type receiver (let it be D8 mode as example and FrSky XJT module), should I set mode on transmitter case by setting switch 1 on and switch 2 off, or just in this menu I should chose D8 mode and that will be enough? Or maybe I should set D8 mode both using switches on case and in openTx menu?
What will happen if I set different values via switches and this menu? Which settings is more important? Any of them, or it won't work with different modes set?