XJT Mode - switch on module case or in model settings

Post Reply
morel
Posts: 8
Joined: Fri Dec 02, 2016 3:38 pm
Country: -

XJT Mode - switch on module case or in model settings

Post by morel » Fri Feb 09, 2018 10:39 pm

When setting model, we can bind receiver and transmitter from model setup panel. There are also other transmitter settings - for example mode.
And here is a question: when I want to bind particular type receiver (let it be D8 mode as example and FrSky XJT module), should I set mode on transmitter case by setting switch 1 on and switch 2 off, or just in this menu I should chose D8 mode and that will be enough? Or maybe I should set D8 mode both using switches on case and in openTx menu?
What will happen if I set different values via switches and this menu? Which settings is more important? Any of them, or it won't work with different modes set?

User avatar
MikeB
9x Developer
Posts: 15787
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: XJT Mode - switch on module case or in model settings

Post by MikeB » Fri Feb 09, 2018 11:56 pm

No need to use the switches on the back of the module, always just use the menu. The switches are only there for the case where the module is used in a Tx that only outputs PPM and so cannot have a menu for the settings.

Mike
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Post Reply

Return to “openTx model setup”