Can someone explain how to set rates and expo independ.on separate switches

Post Reply
Para9111
Posts: 2
Joined: Sun Oct 01, 2017 6:52 pm
Country: -

Can someone explain how to set rates and expo independ.on separate switches

Post by Para9111 » Sun Oct 01, 2017 6:55 pm

Taranis/OpenTx :?
Can someone explain how to set rates and expo independ.on separate switches
I know how to add dual rates and expo under input but I'd like to have expo on one switch and dual rates on another switch.I want to have 3 different weight values connected to one sw and varies expo values connected to another sw.Ive been reading watching videos but they explain the same procedure adding it together so you can never say cancel expo and say use a high rate.Can someone point me in the right direction please.

Richard
Posts: 168
Joined: Sat Mar 29, 2014 10:44 pm
Country: United States
Location: Coral Springs, FL

Re: Can someone explain how to set rates and expo independ.on separate switches

Post by Richard » Tue Nov 21, 2017 4:12 pm

About the "Expo" switch, you can define one mix with one Expo, and another, controlled by the switch with a different expo, and as "Replace". Therefore, with the switch in on position you have expo "1" and in the other, expo "2". If, on top of that you have dual rates, then you have to duplicate the mixes. I will try to make it simple in this example:
Elv Source Ele, weight 100%, expo 30
Source Ele, Weight 70%, expo 30, Switch SA UP,
R Source Ele, weight 100%, expo 20, Switch SB UP
R Source Ele, weight 70%, expo 20, Switch L1

And define L1 AND SB UP , SA UP.

Please, check this config up before flying. I never used anything like that in my planes, but that is the setup I would use to close up to your objectives.
Richard

Post Reply

Return to “openTx model setup”