Search found 10124 matches

by Kilrah
Wed Apr 22, 2020 2:59 pm
Forum: FrSky Taranis radio
Topic: Taranis QX7 bluetooth
Replies: 164
Views: 44904

Re: Taranis QX7 bluetooth

Maybe the bootloader is incorrect or didn't flash?
by Kilrah
Tue Apr 21, 2020 8:49 am
Forum: FrSky Taranis radio
Topic: Taranis QX7 bluetooth
Replies: 164
Views: 44904

Re: Taranis QX7 bluetooth

Don't know, all I could find is I used my FTDI. Don't remember if this pic was of flashing the bootloader or the firmware.
20170912_173502.jpg
by Kilrah
Sun Apr 19, 2020 6:08 pm
Forum: openTx
Topic: How to make a PID-Controller: control the throttle (ESC) for a given RPM (governor)
Replies: 18
Views: 844

Re: How to make a PID-Controller: control the throttle (ESC) for a given RPM (governor)

Between the slow and multiply in mixer it should be possible to do something...
by Kilrah
Wed Apr 15, 2020 8:09 am
Forum: er9x
Topic: Throttle range no 0 to mid range only mid to 100%
Replies: 2
Views: 258

Re: Throttle range no 0 to mid range only mid to 100%

You did not center the throttle stick when asked during calibration.
by Kilrah
Sun Apr 12, 2020 9:45 pm
Forum: openTx for FrSky radios
Topic: X8R Bind Issue
Replies: 2
Views: 192

Re: X8R Bind Issue

What firmware did you update?
Are the receiver and radio of the same region?
by Kilrah
Mon Apr 06, 2020 5:20 pm
Forum: er9x
Topic: rewritten protocol frskyX v1and v2.1.0
Replies: 6
Views: 646

Re: rewritten protocol frskyX v1and v2.1.0

No, has nothing to do with it. "Full telemetry support" has always been there, what's sent is determined by the connected in your case iNav, you need to look at its doc to see what each value means and what's configurable.
by Kilrah
Mon Apr 06, 2020 2:36 pm
Forum: openTx
Topic: X9D+ Trainer port PPM?
Replies: 2
Views: 388

Re: X9D+ Trainer port PPM?

Did you set the trainer mode to slave?
by Kilrah
Sun Apr 05, 2020 12:26 pm
Forum: General help (FrSky Taranis radio)
Topic: SD CARD WARNING
Replies: 2
Views: 467

Re: SD CARD WARNING

Not updating the SD card contents along with it.
by Kilrah
Sat Apr 04, 2020 4:24 pm
Forum: Software
Topic: Companion simulator question
Replies: 4
Views: 575

Re: Companion simulator question

Simply a new feature added.
by Kilrah
Sat Apr 04, 2020 11:48 am
Forum: Software
Topic: Companion simulator question
Replies: 4
Views: 575

Re: Companion simulator question

There is no setting for it.
If you click the "hold" button it'll go back to center.
by Kilrah
Fri Apr 03, 2020 8:36 pm
Forum: Hardware
Topic: Taranis X9-Lite Will Not Switch On
Replies: 3
Views: 467

Re: Taranis X9-Lite Will Not Switch On

You apparently flashed power off, so just do the same thing but this time with the right firmware (you probably used one for the wrong radio).

FrSky's naming is confusing and it wouldn't be the first time someone mixes up Xlite and X9lite.
by Kilrah
Fri Apr 03, 2020 4:02 pm
Forum: openTx for FrSky radios
Topic: X9E transmitter resets on upgrade to 2.3.7
Replies: 18
Views: 1017

Re: X9E transmitter resets on upgrade to 2.3.7

See Nightly builds on http://www.open-tx.org/downloads
Download and install the latest companion nightly, launch it, go to settings, set to nightly release channel, download firmware.

But before that, have you tried if it did it on all models or only some? If only some, which ones?
by Kilrah
Fri Apr 03, 2020 11:12 am
Forum: openTx for FrSky radios
Topic: X9E transmitter resets on upgrade to 2.3.7
Replies: 18
Views: 1017

Re: X9E transmitter resets on upgrade to 2.3.7

Not able to reproduce even with your EEPROM and the samr firmware variant.

Can you backup your SD contents to a folder on your computer, format the SD and copy the files back?
by Kilrah
Fri Apr 03, 2020 7:41 am
Forum: openTx
Topic: Ailerons moving slow & with delay
Replies: 39
Views: 8970

Re: Ailerons moving slow & with delay

Your gimbal pot is faulty.
by Kilrah
Thu Apr 02, 2020 1:51 pm
Forum: openTx for FrSky radios
Topic: X9E transmitter resets on upgrade to 2.3.7
Replies: 18
Views: 1017

Re: X9E transmitter resets on upgrade to 2.3.7

Can you post your eeprom? Ideally use "backup eeprom" on the hardware page, zip and attach the file found in the EEPROM folder
by Kilrah
Thu Apr 02, 2020 6:00 am
Forum: Software
Topic: Multimodule does not show up in Build options
Replies: 1
Views: 360

Re: Multimodule does not show up in Build options

Since 2.3.0 multi is always in.
by Kilrah
Wed Apr 01, 2020 5:42 pm
Forum: General help (FrSky Taranis radio)
Topic: HELP AGAIN s6r
Replies: 4
Views: 476

Re: HELP AGAIN s6r

Only if you need to configure parameters in there...
by Kilrah
Wed Apr 01, 2020 5:41 pm
Forum: OpenXVario - an open source vario supported by the open source firmwares!!
Topic: GPS & Arduino Pro mini
Replies: 33
Views: 4545

Re: GPS & Arduino Pro mini

No, you'll always need something to do the translation.
by Kilrah
Tue Mar 31, 2020 9:14 pm
Forum: Software
Topic: Teensy + Crossfire (or other module)
Replies: 1
Views: 203

Re: Teensy + Crossfire (or other module)

Not that I know of, but the code for both is there in OpenTX and ready for your to wrap and use :)
by Kilrah
Tue Mar 31, 2020 6:27 am
Forum: openTx
Topic: Analog voltage sensor A2 alarms
Replies: 2
Views: 263

Re: Analog voltage sensor A2 alarms

They were deemed unnecessary since you can replicate them and make more complex ones using logical switches and special functions.
So you can set up an LS to be on when A1 < somevalue, then use that LS to trigger a play sound, play voice or whatever else you'd want.
by Kilrah
Mon Mar 30, 2020 5:38 pm
Forum: General help (FrSky Taranis radio)
Topic: can't bind s6r with new fw
Replies: 6
Views: 431

Re: can't bind s6r with new fw

Yes the versions must match. I believe the 2.1.0 for SxR is still under testing.
by Kilrah
Mon Mar 30, 2020 6:09 am
Forum: Turnigy 9XR radio
Topic: Writing firmware to radio only reads?
Replies: 7
Views: 1635

Re: Writing firmware to radio only reads?

OK, it's doing the eeprom backup... Don't remember if there's a way to disable that, haven't touched an AVR radio in 6+ years :(
by Kilrah
Mon Mar 30, 2020 6:07 am
Forum: General help (FrSky Taranis radio)
Topic: can't bind s6r with new fw
Replies: 6
Views: 431

Re: can't bind s6r with new fw

This is OpenTX firmware, but to use receivers that run 2.1 what you need is to also update the radio's internal RF module. Similar to the receiver, get the firmware for that as an frk file from FrSky's website.
by Kilrah
Sun Mar 29, 2020 9:49 pm
Forum: Software
Topic: SD Card Folders with .EXE extension???
Replies: 3
Views: 279

Re: SD Card Folders with .EXE extension???

You might want to format the card and download/copy the standard files onto it again.
If something similar happens you'll likely need specialized services to fix your computer.
by Kilrah
Sun Mar 29, 2020 9:43 pm
Forum: Turnigy 9XR radio
Topic: Writing firmware to radio only reads?
Replies: 7
Views: 1635

Re: Writing firmware to radio only reads?

Untick "check hardware compatibility" on the flash dialog, some USBASPs fail when doing 2 operations back to back.
by Kilrah
Sun Mar 29, 2020 7:29 pm
Forum: openTx
Topic: AFHDS2A bind two receivers
Replies: 5
Views: 458

Re: AFHDS2A bind two receivers

Ah on the same model, then no, not with FlySky protocol. Would need 2 modules.
Pretty much all other protocols allow it.

Go to advanced search