Search found 7 matches
- Mon Oct 06, 2014 3:57 pm
- Forum: Hardware
- Topic: Antenna HELP
- Replies: 2
- Views: 2330
Re: Antenna HELP
thanks, that is it. i have found some and in the process of ordering them.
- Mon Oct 06, 2014 4:23 am
- Forum: Hardware
- Topic: Antenna HELP
- Replies: 2
- Views: 2330
Antenna HELP
does anyone know where i can buy the connector that would be soldered on the board for this antenna? or does anyone know what this connector is called so i could search for it? i have the 9X TX and i bought the Orange RX TX box that plugs into the back, unfortunately they have now changed it and the...
- Wed Jul 30, 2014 10:27 pm
- Forum: er9x
- Topic: servo park or neutral position issue
- Replies: 6
- Views: 4040
Re: servo park or neutral position issue
Thank you all for your help, that is what i needed to do. now i guess i still need to use the mixing menu for flaperons correct? i am using the 3 position switch on the front top right, AUX3 F. MODE [MIX.] switch. i have up as nothing, middle as 40% flaps and down as 70% flaps.
what do you think???
what do you think???
- Wed Jul 30, 2014 11:56 am
- Forum: openTx
- Topic: cutting a hole for programming port?
- Replies: 5
- Views: 4341
Re: cutting a hole for programming port?
i thought about the batery compartment, only reason i was hesitant is if i need to take it apart i can seperate the halves very easly. May i ask why you need to hook into that port every couple of days? i did fly nitro but now because of how cheap electric has become i have switched to brushless. i ...
- Tue Jul 29, 2014 12:02 pm
- Forum: er9x
- Topic: servo park or neutral position issue
- Replies: 6
- Views: 4040
Re: servo park or neutral position issue
I think i get at least part of what you are saying. it sounds like they way i have it setup is it has dual rates for the trim essentially. example (not exact numbers) if i have moved the trim 3 clicks down, and then i flip the switch to dual rates then the trim moves 5-6 clicks down, and this is whe...
- Tue Jul 29, 2014 1:09 am
- Forum: openTx
- Topic: cutting a hole for programming port?
- Replies: 5
- Views: 4341
cutting a hole for programming port?
just wanted to take sort of a pole, how often do you use the programming port? I just have in inside my radio, just have to take the halves apart to get to it. would you say it is worth it to cut a hole for it so I can access it anytime or keep the clean looking case? I painted mine white and black....
- Mon Jul 28, 2014 11:48 pm
- Forum: er9x
- Topic: servo park or neutral position issue
- Replies: 6
- Views: 4040
servo park or neutral position issue
What steps will reproduce the problem? 1.ail. D/R switch, mixed ail. ch. 4 and 6, ele ch 2, and rudder ch 1, all to go from 40% when switch is up and to 100% switch down, for 3D flying What is the expected output? What do you see instead? when flipped i would expect nothing to happen to the plane ex...