openrcforums

Thanks was able to backup my eeproms data. We did a compare and it check OK. We didn't up load after we saved the file. Were going flying tomorrow and didn't want to take a chance that forced me into 2 hours of programing the Tx again. LOL It look like it back up OK. It is 4K bytes long. Just got an...

We have done the FLASH but I didn't see how to do the EEPROM area with the SAM-BA program ?

I put a model19 into my Tx it seams OK. My Safety Thu by the THU Cut switch still isn't working like it use to. But if we change one line of the three line mix it works again. We have it so if the Thu Cut switch is on the motor (ESC) inputs are at a -125 and can't get any movement from the Joys to m...

My mixing setup on my ersky9x is missing sections or can't add no working mixes that had work before. In November I updated my 9x Rev b1 and now most/some of my mixes don't work like they did. Like to get the Rudder to work I have to throw the RUD switch. Its not in my mix setup for any switches or ...

we used a smt chip resistor and put it right on Q2 base and emitter .

Doesn't everyone have a 10K 602 part. LOL
It all most look like a factory part. LOL

Charles

Yes it sounds like the diode. Thanks

I haven't been keep up with the Forums like we should.

I take it the SD card now can be installed and save my planes on it .

Thanks we try it some time this weekend .

THANKS

My board is a Rev. B1
By my O'scope it was the biasing of Q2 form my slave having a
small DC offset of .5 volts that made it not work.

This year up updated our 9x to the new ersky9x board. Before we update we used the training function not a lot but we did use it . This week we tried to use the training function and we couldn't get it working. We was using our normal Tx as a slave. It just would not work. So we started to trouble s...

Hi MikeB we got our ersky9x up and running with BT . I can tell it even seams like the Servo's are even reacting faster with the new board. We like the Custom Display we can all most get all we want on the Display. We would like a readout of Watts. What were lacking is Watts { A1(Volts) * (A2)Amps} ...

I have one of my planes that have a servo for each AIL. Here is the mix that we used to get that operation for both Ch2 and Ch7 CH02 +100%AIL * +50%P1 Switch(AIL) Offset (-50%) +100%AIL Switch(AIL) Ch07 -100%AIL * +50%P1 Switch(AIL) Offset (-50%) -100%AIL Switch(AIL) We have figure out how to turn t...

An idea ! On the main page is it possible to show the Last newest 20 post on all forums here. If you wanted to add a reply to a post it would put it in the correct area of that forum / attach it the same location as the original post. That would make it easy to see what has be updated on all forums ...