openrcforums

Hello kaos, I could do automatic flips only on the v949 only because i received rev 01 with dash (it is like v929 firmware). On others you need the button to go to 3d so it is not possible with standard 9x. Only thing you can do with v959 and 9x if you want flips is to by a v929 board and mount it (...

I red more things about it on french forum, it seems I have a former revision of software close to v929 that makes automatic flip at 100% of stick mouvement and the button was used for lights. rev01/02 with white dash = avanced v929 software = the one I have, makes automatic flips at 100% of stick a...

Hello, Me again, I don't know if it can help but I was amazed to make flips like with button on my new v949 and my 9x without doing any mod on it. I just tried it with my setting of the v959 that are 120% of in all directions on right sitck .... and it makes flips like flip buttons in all directions...

Thanks :D the test was not easy for me if you look at the picture of the board, it was my first cms µc replacement (as you can see I had to rewire a lot of strips with wires because i broke it during desoldering) I also made bridges on some via on this side because I broke strips under the µc. http:...

IT WORKS !!! :shock: Thanks very much Mike for your time my 9X seems to be working now, alls channels and switches seems to work, I'll try tomorow with HF module because I gave mine to a friend for his V911. Now, I'll read ER9x manual so I can program my quad and planes tomorow. Seems to be very pow...

I confirm I have 64A.

It is better, it is written bad eprom data on the LCD, I don't know if I do flash the right way, I put .hex in flash and click Program. But I never put anything in EEPROM .hex in studio 4, is it ok ?
Thanks

Hello Mike, Studio 4 perform a check after programming and it is written OK after test. I also checked reset line and it is not short with ground (there is only the small yellow cap). I double checked also all ground and 5v supply at atmega it is ok there is only Aref that is not linked to 5v I don'...

I use STK500 with studio4.
I put your fuses and load again er9X, it is the same.

No bip no light.


I checked 5V at switches there is no voltage at all.

So atmega doesn't start ? but why ?

Thanks for your messages, yes I'm from France Versailles so a bit far from US. You are right I think I would not pay more 20$ in parts as it would be more interesting to get a new tx. Thanks MikeB for your support, regarding fuses I didn't find what to put so I left original maybe it was a mistake, ...

Hello, I wanted to flash my 9X V2 with er9X so I soldered 6 pin ISP on mainboard. I also short the output diode because I wanted to use battery power on external device. After that, it doesn't want to start, nothing happen no bip no light....I desoldered 6 pin...the same....I check all µc output for...

Hello, thanks Akkuschrauber for your answer, yes I just wanted to make a simple shield that anyone with a arduino uno could flash and use with a trainer port tx but.... first thing I think I burnt my a7105 because I flash arduino with shield on it (and it support only 3.3v max ) and secondly I tried...

Here is the signal I get from trainer port of my T9X, is there something wrong with it to use rc-ppm2spi module ?

Thanks

Hello, Thanks very much for all the work done here to be able to fly wltoys and hubsan. I personnaly own a V911 and recently bought a v959 after reading all this topic i decided to try to get all fnctions of my v959 with the t9x radio. so i unsoldered the a7105 tx module from my v911 tx, flashed one...