openrcforums

Where is OpneTx for X10?
Can't find in OpenTx page.

Thank's,
Just installed OpenTx 2.2 to my HORUS.
It's so nice, maybe I'll never go back to the original Frsky OS.

Great !!!
That's the thing what I was waiting for !!!
By the way can Companion 2.2 backup the original Frsky firmware for just in case ?

You can find it here.
http://downloads-22.open-tx.org/nightly/companion/

But,,,
Horus Tx settings look's strange.
Switchs are Ail, Ele,,, not SA, SB,,,

Seems to be officially released.
http://www.frsky-rc.com/ad/X12S.html

Met Frsky people at Shanghai Model Expo on 22th Aug.
Good news is, they said HORUS will be possible to flash to OpenTx.
Bad news is, the delivery time of HORUS will be two month after.
Normally when Chinese say two month, it means more than four month!

Great !

Can't find Nightly-Builds after 20-May.
Some thing wrong on my PC?

Thank's dinamich。

Yes agree, it's really a minor error.
Hope that will be fixed sometime.

I'm not sure this is the right place to post. On C9X ver1.52. (TARANIS) 1. Create new model by wizard. 2. Select "Glider" 3. Select "V-tail" Mixes for both elevator's weight has opposite sign. --> correct. Mixes for both rudder's weight also has opposite sign. --> fault. For V-ta...

Oh ! got it !
I was wondering that DSM2 selection will effect something in using with OrangeRX's TX module (which I am using now).
It seems that I should still select PPM for OrangeRX module. (Correct ?)
Thank's a lot !

From C9X V1.52, it shows DSM2 on the RF Module 2 selection.
My question is what module matches to this?

Had a same kind of problem before. I'm not sure that my experience is same yours. In my case the USBasp device was the criminal. Tried more than 5 different USBasp device, but did not get any solution. Finally found one device from here only worked. http://9xrprogrammer.com/ Cannot guarantee that th...

It works great!
Also has Japanese (^^).
Thanks!

Thanks for discussing my issue. Honestly it dose not take so much time to re-enter the center value on the limits tab, it just helps me to be little more lazy. I just wondered that if C9X had an one small entry field or drop down tag which can change the default center value, it will really help me ...

The center value on the limits tab is originaly 1500uS. But the FUTABA system uses 1520uS for center. My exsiting planes are all using this center value (1520uS). When I try to switch the TX to TARANIS, I need to reset all the center value from 1500uS to 1520uS. Is there any way to change the defaul...