openrcforums

I installed regular 1k 1/4w resistors. I soldered them near where the traces move from the front to the back of the pcb. This made it a bit easier to older them and spread out the locations where the resistors are placed as these are considerable bigger than the smd resistors. The problem with the f...

So it's probably easier to solder them on the other side of the print, closer to the buttons?

-David

mhotar wrote:They are in series with each switch.
Break the trace and bridge with resistor.

Do they have to be SMS resistors or can I use regular 1/4w 1k resistors that I have lying around?

Thanks,

David

Hello everyone, I've been reading the different posts concerning the freeze/restart problems after installing the microswitches. I'm experiencing the same problem after installed microswitches on my transmitter. I would like to install the fix with the resistors, however I'm looking for some instruc...