openrcforums

I've been using my 9X radio with the open9x firmware plus FRsky DHT DIY Tx with the D8R-xp module, but dont know how to set the telemetry. I have the A1 and X pins on the RX connected with a jumper to enable the internal voltage monitoring of the flight pack. D8r manual says "A1 (INTERNAL): MAX...

Finally got done with this mod and everything works as advertised. Thanks to all.
I'll be buying another turnigy either the 9x or the 9xr and might just get the frsky telemetry/receiver for a lot less mod
Its been almost 30 years since the last time i solder in high school.

My 9x was flashed with open 9x already before i found this telemetry mod.
Will it be okay to reflash my 9x tx again with open 9x firmware but this time with telemetry?
Thanks.

if you are doing the telemetry mod that resistor is not needed anyway.. looking closer, when you cut the trace you disabled it anyway.. which tutorial are you following? Joao I do apologise for saying that the resistors were not needed, hence I asked what tutorial you were following.. As I did my m...

Showmaster and all, Yes the plan is to solder one leg of the regular resistor into the hole (below #2 smd pad) and up to connection 41/42. I was able to connect the #1 smd resistor to connection 41/42 but #2 smd came off in the process. If i saw the pic above before all this it would have been easie...

I'm following the instruction from RCHACKER.COM Yes its disconnected away from the main chip but then again its solder to a wire and onto to the main chip but to a different connection. i will try getting a regular resistor from a local Fry's electronic and solder it in place of the SMD 201. I hope ...

I was doing a mod and one of the smd resistor came off. Can i replace that with a axial leaded resistor with the same value?
Here the link i posted in RCG with picture.
PLs help.
http://www.rcgroups.com/forums/showthread.php?t=1889988