openrcforums

BBC BASIC ?

https://en.wikipedia.org/wiki/BBC_BASIC#Other_platforms

A GPL clone of BBC BASIC named Brandy written in portable C is also available.

Then I broke the connection between upper pads of R83 and R90 when I was desoldreing them.

R22 is OK.
I think the break in the connection occurred when I removed R83 and R90 from the board.
Can you check R83 and R90 on the schematic?

Upper pad of R83 is connected to right pad of R22.
Upper pad of R90 is connected to J3-2.

R22 is 100 ohms.
Left side of the R22 is connected to PC13 (resistance 0.2 ohms).
Right side of the R22 is not connected to pot middle / J3 pin 2 (resistance 2.5 Mohms).

The A9 value should change when you move the pot. 1. Measure the voltage between GND and the middle connection of P4 with the pot in different positions. It should go between 0V and 3.3V. 1.67V in middle position 0.1V and 3.17V in end positons 2. Repeat measuring between GND and the connection on t...

I removed R83 and R90, R22 is on the board (I added it a few months ago). I connected middle wire from P4 (taranis slider) to J3 pin 2. I connected left and right wire from P4 to GND and VCC (from P3). I chose P4 - AD10 in the hardware menu (the only available option). In DiagAna menu A9 is mostly 0...

Is it possible to add POT 4 and connect it to spare analog?
In hardware menu only option for POT 4 is AD10.

I have voice problem with
ersky9xProvR218h 09-Dec-2015
and ersky9xProvR218g 21-Oct-2015

Radio (Turnigy 9xR Pro) says only decimal part of the voltage.
For A2=11.5V it will say "point five volts".

Older ErSky (May 2015) is working OK.

Yes I did, with the dremel.

How to fit Taranis Gimbals to a 9XR-Pro chassis. Part 1 is just the wiring. I would like to say right at the start that there is no angst in this process, there are no special skills involved, no soldering and glue to contend with, this should be a straightforward job which can be completed in an e...

Turn off CrossTrim option in radio setup menu.

This one?
http://www.ebay.com/itm/New-40x20mm-8Oh ... 4d1b7d22d1

8 ohm
2 W
40 x 20 x 8.5 mm

I have the same issue on my radio.
T9x without any mods, er9x NOHT r789.

On er9x, here is what they do. ------------------------------ Description of GVARS in er9x, 04 Mar 2013 GVARS may be used in a number of places. 3. EXPO and Dual Rate. The expo and dual rate values may be set to use a GVAR. This allows the values of these to be adjusted in flight. How can I set dua...

er9x

Plesae can someone tell me how to setup elevon mix with differential.