openrcforums

Hi everybody, I just received my new 9X today, it's a quite good firmware on stock and just tested it on simulator, but what the hell?? changed it from mode 1 to mode 2, changed it to mode 2 in firmware, the elevator stick was out of center (about 10%??). Found how to calibrate it with stock firmwar...

Not getting that one to work.

Fine, I tested it in companion9x, it works great now :) Even works without the slow-option: CS1: v<ofs CH15 -99 CS2: AND TRN SW1 CS3: AND TRN !SW2 CS4 AND !SW2 !SW3 CS5: |v|<ofs CH14 99 Mixes: CH14: +100% CH14 switch(SW2) CH14: R+100% CH14 switch(SW4) CH14: R+100% CH16 switch(SW3) CH14: R+100% FULL ...

A bit difficult, taking a lot of memory and not exactly what I am looking for ;) Channel 14 is at -100 If I switch TRN, it goes up to +100 and stays there no matter how long I hold it and even on releasing the switch. If I switch it again, it goes down to -100 again and stays there no matter how lon...

Next release?
Any other suggestions?

Sorry, did you read what I've written?
My issue is about programming, I do not have any problems with switches

Hi everybody, I just started fooling around with companion9x and I absoulutly love this firmware! But I wounder if there is a chance to get this behavior: Channel 14 is at -100 If I switch TRN, it goes up to +100 and stays there no matter how long I hold it and even on releasing the switch. If I swi...