openrcforums

Hi, I'm trying to use the S1 pot (well any of the rotary pots) to control the gain on my tail gyro. In the mixer screen I can't find any of the pots listed in the switch drop down. What am I missing here?? Can someone / anyone advise please?

Many thanks in advance

Jim

My current settings for normal flight... Mysettings I'm using the 3 position switch for flight modes on my Naza H. How would I add a mix with following throttle / pitch curves for inverted flight on say the AIL/DR switch? throttle: 100%, 92.5%, 85%, 92.5%, 100% pitch: 0%, 25%, 50%, 75%, 100% I hope ...

If you launch eepe now, there is an firmware update - think it said R781 version 1.6689. If you flash this to your radio you are then able to change pilot name. I had same problem.

Right! many thanks for all the help, I finally think I've sorted it. No heli template, 4 channel basic, added throttle mix and curve and pitch mix and curve. Added the mix to channel 7 for the 3 way switch and a gyro mix on channel 5 and it now all works - chuffed!! Many many thanks to all of you! H...

FAO Gosht, Ok, here is a lin k to the wiring setup for my IKON FBL controller. Please notice that the pitch is on a channel called CH 4/5/6/bind which is a 3 way lead that came with the IKON. How would I set this up with my er9x TX? I may not reply to you for a while so please bear with me. Thanks J...

A picture of the top would help. The manual for this thing has no pictures, doesn't make for a really useful manual. My $50 flybarless unit at least had pictures in the manual. -Gohst many hanks gohstb, I will post a photo of the unit soon as , but due to personal issues it may not be for a few day...

My esc is attached to channel 3 on my RX (Spektrum 6 channel). Would I still have throttle in the mixer on channel 3? Yep of course. Where does the mix go for the collective?? This depends on your FBL unit and its wiring. The FBL controller will expect pitch on "some wire" you connect to ...

Probably like most flybarless you don't really need to use the heli modes at all. Just give it AIL, ELE, RUD like an airplane. Then you have 2 channels for throttle one controls the motor, and the other controls the collective pitch. Their manual doesn't have any pictures, and there doesn't seem to...

Hi, I do not have an IKON, but I just set up a Skookum 720 and had similar issues. I ended up using 2 channels based on Throttle position. One channel used the Heli template curves 1-3 based on the position of the flight mode switch for throttle and the second channel used the curves 4-6 based on f...

Hi, Please accept my apologies for this question but I'm new to the radio with er9x installed and I'm really struggling to get it setup for use with my new toy a IKON flybarless unit (brain) and my 450 helicopter. It needs to be a 90degree swash H1 and the 3 way switch needs to be set for three diff...