Search found 6 matches

by 123jhe
Thu Jan 14, 2021 9:38 am
Forum: openTx
Topic: throttle mix for smoke system
Replies: 3
Views: 167

Re: throttle mix for smoke system

Correct. You can do that on the mixer directly without logical switch. Sorry. I did that out of habit. You often use a physical switch to control different mixes and so on. That means you configure the same switch with the same 'meaning' in different locations. I always define a logical switch that ...
by 123jhe
Tue Jan 12, 2021 8:39 am
Forum: openTx
Topic: Radiomaster TX16S binds Spektrum AR637T receiver but funny issues
Replies: 0
Views: 132

Radiomaster TX16S binds Spektrum AR637T receiver but funny issues

Hi I've moved the post, since I think I got the wrong section before... Sorry. Hope I'm in the right spot now. I've programmed my Radiomaster TX16S for a while now and it works just great. I normally use Graupner HOTT receivers. Now I'm setting up a Horizon Night Timber BNF with Spektrum AR637TA (BN...
by 123jhe
Tue Jan 12, 2021 8:36 am
Forum: openTx
Topic: throttle mix for smoke system
Replies: 3
Views: 167

Re: throttle mix for smoke system

Hi I would approach it like this: 1. assign a logical switch to the physical switch you would like to use for on/off switching 2. create a mixer on the channel connected to the smoke engine, use throttle as source AND set switch to the logical switch from step 1 This way throttle gives the input, bu...
by 123jhe
Mon Jan 11, 2021 9:41 pm
Forum: General Information & Rules
Topic: moved: Radiomaster TX16S issues with Spektrum AR637T receiver
Replies: 0
Views: 191

moved: Radiomaster TX16S issues with Spektrum AR637T receiver

I moved this post, since I think I put it in the wrong place.
Can anyone tell me how to delete this post? Thx

New place: https://openrcforums.com/forum/viewtopi ... 45&t=13155
by 123jhe
Mon Jan 11, 2021 9:26 pm
Forum: openTx
Topic: Glider crow brake in flight mode - tricky difficulties with camber offset
Replies: 2
Views: 262

Re: Glider crow brake in flight mode - tricky difficulties with camber offset

@Carbo: Thanks for your reply. I did follow the idea and it works better.
by 123jhe
Sat Nov 21, 2020 11:13 am
Forum: openTx
Topic: Glider crow brake in flight mode - tricky difficulties with camber offset
Replies: 2
Views: 262

Glider crow brake in flight mode - tricky difficulties with camber offset

Hi I've built a complex template for gliders, that supports all setups from 0 to 4 rudder wings with standard Rud/Elev over V-Tail or even Delta wings. I can configure the basic setup with mixers and trim most important mixes in flight. But I'm running into a problem with crow brake that I don't kno...

Go to advanced search