openrcforums

HuWo wrote: ↑Sun Dec 13, 2020 11:39 am I hope you are prepared for the one or other nooby question that might be put

Of course, I will try to answer the questions.
And CatRovacer knows a lot too, now it's a joint project.

Source codes of the ER9X project for I6 and I6X as is.https://bitbucket.org/KotelloRC/erfly6/src/master/

MikeB wrote: ↑Tue Dec 08, 2020 11:08 am Is the source on Github, if so where?

The source is located on Bitbucket, but closed for now. I'll open it later, a lot of rubbish, cleaning is necessary.

For those wishing to test fresh firmware - Version 2.00 FSI6.zip FSI6X.zip For the user, it is identical to version 1.11 The difference is that the code has been moved to the project for SEGGER Embedded Studio (free for non-commercial use), the functions working with hardware have been rewritten man...

RF-module FlySky-I6X https://youtu.be/n0wzpSjb3EI

Wimh wrote: ↑Wed Dec 02, 2020 10:38 am Thanks, I found the instructions in the Russian thread you linked and translated them to English with the help of Google. If there are no obvious mistakes, I'll clean it up a bit...

Thanks for the translation, did you try to reflash the transmitter?

Can I use the programmer and software from Flysky? No, you need a J-Link programmer, the same or similar https://aliexpress.ru/item/4000143068291.html?spm=a2g0o.productlist.0.0.500d74dey8maq5&algo_pvid=5f644f30-2af9-4270-9fa9-7a33e4bcdc18&algo_expid=5f644f30-2af9-4270-9fa9-7a33e4bcdc18-13&a...

FlySky I6X

There is no circuit and code ...
HDD,containing the project - went to heaven.
All over again....

I saw that the receivers like IA6B and X6B both have the same RF module as the TX, so I was thinking about using an RX as a TX module Thanks for your efforts Indeed, a TX module can be made from the FS-IA6B receiver. I already did this for SANWA-SD6G (built-in was broken). It is enough to flash the...

Yes, using an internal RF module, implemented by AFHDS2A. AFHDS is not available yet. The firmware has been working for a long time, I have not looked here for a long time. At the moment, a project is being prepared for 2 transmitters I6 and I6X at once. This project will be published on GITHub. The...

The RF-module is working https://youtu.be/6DephUlm9Xw

I continue to work.
PiSpkr activated.
The PPM output is activated.

Testing the PPM output and exponent on the simulator https://youtu.be/h-IRp01bjrE - look!

Mike, can I ask you questions?
I do not yet understand the organization of the menu, I need to remove the items that are unnecessary for the FS-I6 and add the ones I need.

(I use Google translator, I don’t know English very well)

Processor -MKL16z64 64kb flash 64pin.
I use Kinetis Disign Studio for porting.
Now I'm working on PPM-OUT, I need to check everything in the AeroFly simulator.
Then I will activate the radio module

Hi pilots and developers! I started work on porting the wonderful ER9X firmware to the FlySky -I6 transmitter. There is already some result. You can watch the video.https://youtu.be/nmXNQ-JMpLk