openrcforums

Tar for that reply, no problem with the SD card just the Horus

Hi I'm no expert I believe this could be one of the early ones. My Horus10s has an internal charging censer and a 18 volt 1 amp wall charger . I'm sure someone can conform it one way or another for you

Hi,I don't seem to be able to eject Horus from my Mac when I'm finish, but have no problem ejecting the SD card. Any thoughts please

Sorry I should of said X9D plus SE, but even so would it be possible to fit an internal antenna anyway like the horus?

Could I ask a question. I don't own a Taranis X9D plus, but have read numerous articles where there has been antenna issues with the sma connector(constantly being removed). Would it not be possible to fit an internal antenna as in the Horus 10.Curiosity is a terrible thing

Sorry I didn't say thank you Kilrah ,once again

That seems hard work, but thank as long as it's not me. Tar

What I'm trying to achieve is, when I highlight the model name I'm looking for something to press to delete it . What do I press?

I'm a little reluctant to ask the question, at the risk of being accused of being a noob. But here go's, how do I delete a model name only and not the model .I'm running opentx on the horus10

Thanks for that, as I've read conflicting stories. Anyway my friend will be happy to hear that, Tar

Hi, is it possible to flash the above from international firmware to eu firmware and what problems I'm likely encounter please

Thanks for the reply, that's satisfied my qurirosity

Perhaps someone could tell me, what is the difference between X9D and the X9D Plus ?

It seems that I have resolved my own problem,I recently copied a model profile which was originally intended for X9D and I think it must of also copied the transmitter setting as well. When checking my Horus I notice the the voltage had altered well above the voltage of the battery, hence the warnin...

Hi all,attempted to charge the Horus last night, only to find that it was still flat after charging. The green light comes on at the start and goes out at the end as normal. Any thoughts as what might be wrong

Thanks Kilrah, I must of over looked that and now works fine

Okay, I will try again thanks

Hi,a quick hello first as this is my first post. I've recently flash the Horus over to Opentx 2.2.2 and have notice that when calibrating sticks etc pot S2 in the display only moves from the centre to the far right and not to left. I'am assuming it me,but not sure