openrcforums

I have the RadioMaster TX16S and bound up some Graupner Hott receivers. The LUA script is impressive how you can view and change your settings like a Graupner radio does. My issue is the vario and possibly other sensors. I have a two Hott receivers one with an internal vario and a GR-16L with an ext...

You don't have to copy anything my settings were wrong. You want to use Vspd, not Vario for the tones.

I don't like the bump in the center of the side slider on the X10S. I use that control for my sailplane flaps I find the bump very clunky. Does anyone know of a replacement POT that does have the center bump?

There is a topic on RCG where the vario tones don't work if you built the model with a different receiver and then switched to the GRX8. I started with a S8R RX for my glider, switched to the G-RX8, rediscovered the sensors but you cannot get the vario tones to work correctly. The only solution this...

I just Googled what a STK is. It's a shame the radios don't come with the basics. I don't have one. Are there any other tools/dongles I should get? My primary interest is sailplanes (no gyro RX) and 3D foamies (Gyro RX). I will want talking varios for my sailplanes and from what I read the G-RX8 has...

I assumed it was off since wiggling the RX around did not move the servos. The good news is a G-RX8 receiver showed up today in the mail and it travels the full range of the sticks. So I need to learn the radio and the gyro RX is probably not the place to start. Thanks for help Mike, I will be back ...

The gyros are not enabled.

I'm stuck. I have a S8R receiver bound and 4 servos hooked up to a X10s. Thr, Rud, Ail will not use the full range of the sticks. The servo stops moving after about 50% stick travel, if you keep moving the stick past 50% the servo does not move. The Elev behaves normally. I have run through the stic...