MikeB very thank You for the advice. The RX works well now. I set it to user mode and after communication break is switching off the motor a setting up the stabilization.
Jirka
Search found 5 matches
- Thu Nov 09, 2017 4:42 pm
- Forum: tgy9xr
- Topic: Setting failsafe
- Replies: 6
- Views: 8968
- Wed Nov 08, 2017 11:39 pm
- Forum: tgy9xr
- Topic: Setting failsafe
- Replies: 6
- Views: 8968
Re: Setting failsafe
Thank you for answer. Unfortunately, upgrading the firmware to version 221F4 did not help. It seems to me that only the failsafe mode can be selected. For me, either RX or user mode would be appropriate. Unfortunately, I'm not able to set up the failsafe mode on the receiver, so I can not use it now...
- Tue Nov 07, 2017 4:05 pm
- Forum: tgy9xr
- Topic: Customizing 9XR-Pro signal outputs
- Replies: 2
- Views: 5944
Re: Customizing 9XR-Pro signal outputs
To the second question:
You can use simple integrated circuid with ofset and amplification, to can set output in the range 0 - 5V. But this solution will not be too precission and not too noise resistant .
Better is sove it digitaly.
You can use simple integrated circuid with ofset and amplification, to can set output in the range 0 - 5V. But this solution will not be too precission and not too noise resistant .
Better is sove it digitaly.
- Tue Nov 07, 2017 10:01 am
- Forum: tgy9xr
- Topic: Setting failsafe
- Replies: 6
- Views: 8968
Re: Setting failsafe
Thank for your answer Mike. I have ersky9x-R220. Module XJT
Jirka
Jirka
- Tue Nov 07, 2017 12:02 am
- Forum: tgy9xr
- Topic: Setting failsafe
- Replies: 6
- Views: 8968
Setting failsafe
Hi I would like to set failsafe mode on RX S8R. I tested all modes in menu Protocol -> failsafe and I can't set, when RX loose signal, switch off the trotle and switch on the stabilization. Can You help me?
Thank you Jirka
Thank you Jirka