openrcforums

I think, i am going to stick with FrSky then.

Thanks
Gerry

Hi, im intend to use a Jeti JR-compatible Module with my AR Uni Board and im searching for information how to use the telemetry port. I have seen Jeti related files in the soure tree, but i have no idea how to connect the telemetry port to the AR Uni board and how to enable the Jeti-protocol in Ersk...

Ahh! Thank you Mike.

Gerry

Hi,
simple but maybe not so stupid question: What does a blinking "L" on the Telemetry screen (right behind the title) mean? Is something low? Haven't found an answer in the documentation.

thanks in advance

Gerry

Small problem: internationalization isn't working on my Mac. Even if i place the needed *.qm files inside a eepfiles folder inside the MacOS folder inside the application bundle. Without it i can only choose "english (default)", with this folder in place, i can choose "german" fr...

OK, you're right, its 0x30. A look im my source reveals that i have already written the needed code for the vario-signal. Just used another DataiD (0x40). i'll try it tomorrow.

Thanks for your help kilrah!

Gernod

OK. In fact i am using a homemade sensor which uses the FrSky protocol. If i modify it to calculate and transmit the vertical speed, it should work? Which DataID should i use? The sensor-hub manual says nothing about vario or v-Speed.

Thanks

Gernod

2.0.8. As i said, display of Altimeter is correct, but VSpd stays at zero.

Kilrah wrote:Source would need to be Vario.

The only source options i have are: Alt, Alt+ VSpd, A1 and A2.
If i choose VSpd in the telemetry screen, it stays at 0.0.

Hi everyone, i have some problems with the vario function in openTX 2.0x. I am using the FrSKy Sensor Hub and the old Vario sensor. The altimeter readings are ok, but i am not able to get the vario funktion to work. Settings are: Proto: Hub, Source: Alti, Limits: 0,5 and 3. If i decrease the first l...

OK, thanks!
Next time on googlecode. I promise.

Gerry

Hi, i have a problem when reading the EEPROM from my TH9x (stock) with FrSKY Telemetry. I have set the RSSI alarms to orange = 43, red = 40. But in Companion9X both read as 48. Firmware: opentx-stock-frsky-templates-nosplash-audio-gvars-dblkeys-battgraph-thrtrace-pgbar-de-r2647.hex Companion9X: 1.41...

Same here (open9x-stock-templates-potscroll-de-r1452). Another problem: horizontal movement of right stick (Aileron/Rudder) is inverted on graphics. Gerry Is this one one of the latest radios (no module) from HK ? There are a lot with inverted pot. :( you need to invert wires on the PCB It is! I su...

Ok and thanks for the info. I have open9x-stock-frsky-templates-ppmca-potscroll-autoswitch-dblkeys-pgbar-imperial-en-r1452 as the options loaded and now I would like to know where the mode for the tx went to it seems to be missing from the bottom of the page 1 of 6 for the radio setup. It was the l...