openrcforums

Hello Bob195558, Thanks for your clarification on the rebooting problem. I have two 9x radios with the 9Xtreme add-on boards installed & haven't had a reboot in 2 years so it appears not to be a game changer for me. Nor, do I have the freeze problem. However, I'll follow your link and attempt th...

Hello Joao or Bob, Is there a youtube video of how to do the horizontal digital ground trim fix? The links to the photos are totally confusing and not clear at all. If no video is available can someone seriously consider making one? It appears that this fix is really necessary to fix the 9x radio fo...

Hello Mikeb, Regarding your test versions, for he 9Xtreme radio is the version ersky9x9xt_Rom.zip dated 02-Jul-2016 the best to se or the earlier version ersky9xProvR219.zip dated 22-May-2016 the better firmware? I assume all the firmware denoted by ***_music .zip are all appropriate for the 9Xtreme...

Hello bob19998,
What rev of firmware are you using for the 6 position switch? I have ersky9x-r218 dated 8/26/2015 but the hardware menu has no mention of a 6 position switch.
Thanks, Birdman

Hello Joao,
From your note on June 4th concerning the protection Schottky diode what diode did you order?

There are two types: MBA340T3 or MBA340T3G?

Thanks

Hello Joao, From my previous note I as referring to the 9 pin connectors that are connected to the 9x main board allowing access to XT1...EXT8 for switches, pushbuttons & sliders. Where do you get the 9 pin connectors if you don't use Tyrannis gimbals and cut off its 9 pin connectors? Are these ...

Thanks again for the info. Again one more question.

For the reverse polarity protection diode shown in your photo on the first page of this thread (circuit board FS-TH9-FRONT) what are its specs?
Thanks.

Thanks for the info for the vibration motors and oush buttons. Already on order. Just a few more questions about materials. 1. Where to order the copper clad PC boards for the pushbuttons? 2. What is the diode specs for reverse polarity expansion? 3. Where to order connectors for 9Extreme pc board i...

Where did you purchase the haptic vibration motors? The push buttons? Source and cost?
Thanks.

Thanks Mike. That procedure of copying models from eepe to eepskye works. Thanks for the tip. Will save me hours if inputting models manually.

I have a question related to the eepSkye program that is required when using 9Xtreme hardware update to the 9X Transmitter. I've used older 2 boards (9x TelemetrEZ and the 9x Solderless Programmer Board Rev 2.4) to update my first 9X transmitter and saved all my model settings in the older program e...