openrcforums

Hi Guys,
I've been asked to look at repairing a Flysky i10 transmitter.
The screen works, but the touch screen is not operating.
Any pointers please?

Dave

Eventually installed 2.3.9, and powered up.

The external module now works correctly.

Can only presume a bug in the new firmware.
Where can I report it?

Installed a firmware downgrade to 2.3.9.
Tried due to external TX problems.

Read firmware from my other x9e, which is working correctly.
Write firmware to this x9e.
Will not power up on POWER button.
Remove battery and coin battery.
Still will not power up.
Any Ideas?

Turned both switches to the ON position, re-bound the No3 receiver, works fine

Thank you Kilrah.

Both switches are in the off position, I'll put them 'on' and see what happens

X9E with additional XJT module. open tx 2.3.9. 2 8XR receivers. 1 RX6R receiver. When binding I have internal XJT D16. First receiver 1 ch 1- 8 no telem Second receiver 1 ch 9 - 16 with telem external XJT D16 third receiver(RX6R) 1 CH 17 -22 no telem Am I correct with all receivers as 1, or should t...

Hi Guys,

I need to program a 9XR PRO with a channel that continuously cycles from -100 to 100.

I've looked through eePskye but can't see how to program the channel.

H.

Thanks for the reply Mike.

Fully understand the reason for witholding the drawings,

I had a problem that turned out to be a 0.1 ohm resistor was measuring 470 ohms on the rf board.

Dave

Hi Guys,

I've located the various wiring diagrams for the 9XR Pro transmitter. Many thanks to those who posted them. Also for the switch modifications.

Are there any circuits for the PCB's?
I'm an electronic engineer, and the circuits interest me for information and fault finding.

Hi Guys,

I'll trying to replace the USB/SD board on a 9xr pro.

HK don't list it as a spare.

Is here another transmitter that has the same boards?

Thanks

hubsy