openrcforums

I've double checked my gimbal wiring, and it was a bad contact on soldering.
This problem was caused by gimbal move, and the wire wasn't guided around the gimbal.

Thanks for your help guys.

Delay is screened in the "ANA section" too. I've changed gain with no effect on the delay. The stick output only moves half as far when i set gain=1 (ok). The value of A2 (ele) is changing smoothly like a first order filter (not jumping), with a delay of 2-3 seconds My values with a gain =...

Hello Mike,

I've set back to 1 without turning off the radio, but without effect.

I didn't turn the radio off cause I know that it solve the problem.

Is this change (gain) is active without switch off the radio?

Hello, I've sometimes suddently a big latency (like a filter) on the elevon stick. Time between 0% to 100% is about 2-3 seconds. I've v155 of ersky9x firmware and I don't understand why it's only on the elevon stick (rudder, throttle, ailerons aren't affected). I've change ADC filter but no effect. ...

this is about ersky9x voice, don't know I should put this in in er9x voice mod or not. If Moderate think it should, then move it: OK. I retest the ersky9x voic with updated voice files form Jhsa including the 006-0015 for 'point 0-point 9' and I have 400-499 for 0-99 and thousands already Hello, i ...

Hi, Aurora gimbals fit in the 9x. Mines work well, and it's not difficult to make the hack/ You have to : - Unscrew the actual gimbals - Enlarge a bit the gimbals hole - Adjust Aurora gimbals by cutting some plastic which exceed on the new gimbal (like plastic screw hole etc...) - Put some glue arou...