openrcforums

Working with the eePskye Eprom Editor I do not succeed in adding a mix to an existing mix on the same channel.
When I click OK in the specific Channel Window the existing mix is REPLACED by the mix I want to add.
In the multiplex block is filled out ; ADD and not REPLACE



Herman

That setting doesn't mean that you can add another mix It means that the mix you are configuring is an add mix, a multiply mix, or a replace mix. That means that the mix you are editing will add it's value to the result from the mixes above, it will multiply it's value by the result value of the mixes above, or will replace the value from the mixes above with its own value..


To actually add another mix on the same channel in eepskye, right click on the existing mix, and select "Add". Another mix will be placed under the one you've just clicked..

João

Thanks for the answer.

Basically I understand the principle of adding and multilying mixes.
I was looking for that "right click"on the existing mix

Could not find it in the YouTube videos, mostly too fast!