Turnigy9x 128, OpenTX, Telemetrez and Switch Error
Posted: Fri Feb 03, 2017 8:55 pm
Hi, I have been searching various forums and threads for help with a problem for some time, but without success.....hoping someone here may be able to help?
I have a spare Turnigy 9X 128 transmitter that is fitted with a Smartieparts 2.4 board, plus Telemetrez. The latter board is loaded with Telemetrez r90 firmware and with ER9X-128 r820 loaded, everything works fine no problem.
If however, I load OpenTX 2.0.20, having "ticked" the Telemetrez option in OpenTX Companion, the AIL & THR Switch Error is always present no matter what I do!
Having followed Smartieparts, Telemetrez and many other forum threads for some years, I'm quite familiar with the usual sources of this problem and know it's vital to load the correct firmwares etc. This is the first time I've tried using OpenTX on this particular radio, it has until recently always used ER9X. A friend has a 9X that I modified with same two add-on boards.....although it only has the 64 processor.....loaded with OpenTX r2940 and it works fine no problem as well.
Can anyone either suggest where I might be going wrong, or state categorically that my combination of hardware should actually work as intended, as this is driving me nuts!
Cheers for any help
Don
I have a spare Turnigy 9X 128 transmitter that is fitted with a Smartieparts 2.4 board, plus Telemetrez. The latter board is loaded with Telemetrez r90 firmware and with ER9X-128 r820 loaded, everything works fine no problem.
If however, I load OpenTX 2.0.20, having "ticked" the Telemetrez option in OpenTX Companion, the AIL & THR Switch Error is always present no matter what I do!
Having followed Smartieparts, Telemetrez and many other forum threads for some years, I'm quite familiar with the usual sources of this problem and know it's vital to load the correct firmwares etc. This is the first time I've tried using OpenTX on this particular radio, it has until recently always used ER9X. A friend has a 9X that I modified with same two add-on boards.....although it only has the 64 processor.....loaded with OpenTX r2940 and it works fine no problem as well.
Can anyone either suggest where I might be going wrong, or state categorically that my combination of hardware should actually work as intended, as this is driving me nuts!
Cheers for any help
Don