I think this is a stupid newbe question;
Why are here no templates using in combination with a drone/ quuadcopter??
Recently I bought a Turnigy 9XR pro tansmittter with lots of programming possibilities however I have no idea of how to set up it for a quadcopter.
template for quadcopter ??
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: template for quadcopter ??
Hi litse23,
It depends on what Flight Controller you have in your Quad.
It is for the most part, set up like an airplane.
You have a 9x radio using er9x to eepe, so start with the Simple 4-CH Templates. What is the Flight Controller (or kind of Quad) you have ?
OOPS, I see you have a 9XR-pro Radio using erSky9x to eepSkye, it will be the same Mixes.
Bob B.
It depends on what Flight Controller you have in your Quad.
It is for the most part, set up like an airplane.
You have a 9x radio using er9x to eepe, so start with the Simple 4-CH Templates. What is the Flight Controller (or kind of Quad) you have ?
OOPS, I see you have a 9XR-pro Radio using erSky9x to eepSkye, it will be the same Mixes.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).