9XR with Corona DSSS

[Willi]

Dear all,

I have a new TGY 9XR and the Corona DSSS V2 modul.
(http://www.hobbyking.com/hobbyking/stor ... DSSS_.html)

I have make the binding, the red LED on the receiver is on and that show me, that the link from the transmitter
to the receiver must be ok. The servo also make some noice, that is for me the 2. point that the link is ok.

Then i have make a new plane on the memory 1 with a template.

But, when i move the stick's, the servo don't move !!

My problem is, that i can not check the function at them moment, then i don't have a other receiver / transmitter.

Gives there on the 9XR a fault of the setup ?? PPM seetings are on 8 chanel.

Have you a good idee for a solution ?

Thanks for your replays.

Best regards
Willi