Page 1 of 1
9x dsm mod wont bind
Posted: Wed Sep 17, 2014 4:05 pm
by jh1985
i need help i flashed the latest er9x and installed MLP4DSM. When bindinding the MLP4DSM flashed and my spektrum reciever starts flashing different as it normally would during binding. then the light shuts off on the reciever and i get nothing as if there is no radio. i should get a solid light. please help. ive tried several things. it has 4k7 resistor and the diode. the only thing that i dont get is which way to put the diode in. i have stripe closest to the radio. thats the only way i get any reaction.
Re: 9x dsm mod wont bind
Posted: Thu Sep 18, 2014 1:43 am
by jh1985
Anyone? Could It be firmware related??? I can bind with my turnigy module and anylink they all work fine. Im at a total loss. Ive tried to bind with a brand new reciever and 3 bnf micros. It wont even start the bind process on the micros. They just keep flashing like i never turned the radio on.
Re: 9x dsm mod wont bind
Posted: Thu Sep 18, 2014 6:11 am
by jhsa
Please be patient
most of the users from this forum are still sleeping
Did you change the protocol to DSM in the model comfiguration menu? How are you doing the binding?
João
Re: 9x dsm mod wont bind
Posted: Thu Sep 18, 2014 4:03 pm
by jh1985
yes i did. no solid light. the blinking changes speed then the led shuts off thats it. no control at all. like it isnt in the bind process long enough
Re: 9x dsm mod wont bind
Posted: Fri Sep 25, 2015 7:37 pm
by jt41time
Im having the same result. Just got done doing all the wiring. Then i tried to bind to two diff rx. One a ar6200 and one a orangerx. They blind fast, then i hit the power and bind switch, the rx starts to blind a little slower. then lights go out. and nada. It almost there.
Opentx 2.01 mavlink-dsm
I have set it dsm2 and dsmx.