You know that the recent iteration of ER9X >>> SVN: ER9X-r806, Ver: V1.2024-mike, DATE: 15.10.2013, MOD FrSky NT
It has no Templates anymore. Not that I am used to it. I am as new as they come. I have spent more time building and flashing and programming, installing drivers ordering parts and fixing my blunders than anything else. Don't get me wrong, I love every moment of it. But I would like to fly some time in the near future. To that end, I am taking video tutorials with this Richard Mrazek. But his version or build is much older. Maybe a year or better old. But... even the wiki is out of sync. So what to do?
Pp9 is Safety Switches
Pg.10 is FrSky Telemetry, \
Pg. 11 is FrSky Telemetry,
& Pg 12 Global Vars, and that is it.
Back to Screen #1 So....Have they done away with them in this October 15th '13 iteration?
Where have the Templates gone? I am taking a tutorial be Richard Mrazek and it is sort of confusing.
I need a template for my APM FPV Quad build, and a Flaps on Three pos Sw for my AXN Can anyone make suggestion, I have spent most of my time at the bench not at the airfield. The AXN is ready with a new D8RIIplus Rx and my Corresponding DJT module. NAturally I ahve used the ER9X FrSky FW for the upgrade. ANyone care to offer a suggestion. I have many miles to go before I make camp. God Speed and Good Flying folks
New ER iteration from
Re: New ER iteration from
NT in the firmware version means "No Templates".
If you want templates, don't use an NT version.
BTW, you only want the FrSky version if you did the hardware telemetry mod. Otherwise, just use the standad er9x even if you use FrSky RF modules.
If you want templates, don't use an NT version.
BTW, you only want the FrSky version if you did the hardware telemetry mod. Otherwise, just use the standad er9x even if you use FrSky RF modules.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: New ER iteration from
The templates were removed from the FrSky version many months ago. There wasn't really enough flash space with all the telemetry support to include them.
If you use eepe, you can use the templates there. Simply connect the radio t the PC, and use eepe to read the EEPROM, apply the required template(s), then write the EEPROM back to the radio.
Mike.
If you use eepe, you can use the templates there. Simply connect the radio t the PC, and use eepe to read the EEPROM, apply the required template(s), then write the EEPROM back to the radio.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 1844
- Joined: Tue Dec 27, 2011 8:22 pm
- Country: -
- Location: Ottawa
New ER iteration from
Note that the built in templates provide only basic components for programming. What the OP is looking for is something quite different -- ready made programming for specific models. That's not something that should (or could) be incorporated into the firmware; rather, you get it through forums and libraries of resources.