PPM in trainer/TX module
Posted: Tue Jul 02, 2013 10:52 pm
Hi,
that might be a stupid question, but...
The trainer port is a PPM in, right? Is the signal basically identical to the signal sent to the TX module?
E.g., could I connect the module out of one 9x to the trainer port of another 9x?
I'm asking because my integrated GCS is still spinning around in my head and with the Sky9X board not available any more, I'm looking for other options.
I was also thinking of building some joystick box with PPM out to use on the trainer port and from there I had the idea to build my own multicopter-specific TX using Arduino and FrSky modules...
Yet another idea spinning in my head is using an Arduino with USB host shield and make it a USB -> PPM converter...
-Stefan
that might be a stupid question, but...
The trainer port is a PPM in, right? Is the signal basically identical to the signal sent to the TX module?
E.g., could I connect the module out of one 9x to the trainer port of another 9x?
I'm asking because my integrated GCS is still spinning around in my head and with the Sky9X board not available any more, I'm looking for other options.
I was also thinking of building some joystick box with PPM out to use on the trainer port and from there I had the idea to build my own multicopter-specific TX using Arduino and FrSky modules...
Yet another idea spinning in my head is using an Arduino with USB host shield and make it a USB -> PPM converter...
-Stefan