Here is a video that gives an overview of the Companion9x interface. Companion9x is the computer software that is used in conjunction with the Taranis.
http://youtu.be/gEMQlWDoHlc
EDIT: I'm under the impression that Companion9x is going to be changed to CompanionTX -- but I'm still confused on this. At any rate the Firmware that was Open9x is now called OpenTX.
Quick videos to help get started
-
Scott Page
- Posts: 864
- Joined: Wed Dec 28, 2011 3:32 am
- Country: United States
- Location: Tri-Cities, Washington State
Quick videos to help get started
Last edited by Scott Page on Fri Apr 19, 2013 12:42 am, edited 1 time in total.
-
Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Quick videos to help get started
Thanks Scott. Great work. I think this is exactly what is needed.
Rob
Sent from my GT-I9300 using Tapatalk 2
Rob
Sent from my GT-I9300 using Tapatalk 2
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: Quick videos to help get started
Did the name really change in the 2 days I was away??? 
EDIT: No, good
EDIT: No, good
-
Scott Page
- Posts: 864
- Joined: Wed Dec 28, 2011 3:32 am
- Country: United States
- Location: Tri-Cities, Washington State
Re: Quick videos to help get started
I'm not sure what to call it now. Is is Companion, companionTX or still companion9x. I'm pretty confused about this .. I feel I'm getting mixed messages... same with Open9x vs OpenTx vs ???