Trim change with rates
-
- Posts: 28
- Joined: Wed Oct 16, 2013 11:06 am
- Country: -
Trim change with rates
When I switch to a higher rate by having separate mixes with switches selecting the mix the trim drastically changes. This only occurs on the elevator servo.
-
- Posts: 28
- Joined: Wed Oct 16, 2013 11:06 am
- Country: -
Re: Trim change with rates
I haven’t updated the firmware for about 4 years.
- MikeB
- 9x Developer
- Posts: 17995
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Trim change with rates
A mix with a weight other than 100% will affect the trim setting.
The "best" way to handle rates is to use the "Expo/D.Rate" menu as this applies the rate setting to the stick input and doesn't affect the trim in a mix.
Mike
The "best" way to handle rates is to use the "Expo/D.Rate" menu as this applies the rate setting to the stick input and doesn't affect the trim in a mix.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 28
- Joined: Wed Oct 16, 2013 11:06 am
- Country: -
Re: Trim change with rates
Thanks Mike,
I’ll have a go at that as soon as I get the chance to play again.
I’ll have a go at that as soon as I get the chance to play again.