openrcforums

I just received my 9x yesterday. There is something I can't figure out:

When I go to E.Points setting, there are two columns of percentage settings, but I can only go through one of the two percentages for every channel. When I click up or down buttons it jumps through one setting - usually just in the right column, but sometimes on the left (it happens on two channels in airplane configuration). So I can't edit both endpoints of any channel! What am I doing wrong? Or if it's a bug - is there a workaround???

If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.

Ha! It was that simple! I feel stupid. You are correct, it works fine. Thanks!

Kilrah wrote:If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.

Thank you very much Kilrah, I'm just programming my new 9X and I was frustrated by this same issue. I was about to decide I had a bad unit. I'm really happy to have found this answer. Now I feel a lot better about my 9X.