Advice / clarification of setup ersky9x
Posted: Fri Jan 06, 2023 7:42 pm
Hi all
Bloavez mad / Happy New Year one and all!
The following might need moving to a more appropriate forum topic!
I have been asked by a modelling colleague to set up his 9XR Pro to control a 2 motored boat. Fine, i have installed V tail mixing and have both motors working fine.
I have a small problem with the motors, when going either forward or reverse one of the motors starts to rotate about 5 secs before the other motor, and in reverse the same sitution but on the other motors, howcan i adjust the tx to give a situation where the 2 motors start together both in forward and reverse? Do I need to use the curve settings, which i have used previously controlling just one motor and a water jet system. I can see how it might work but i don't have a clue how to do it because of the mix.
Help please!
Thanks
Tony S
Bloavez mad / Happy New Year one and all!
The following might need moving to a more appropriate forum topic!
I have been asked by a modelling colleague to set up his 9XR Pro to control a 2 motored boat. Fine, i have installed V tail mixing and have both motors working fine.
I have a small problem with the motors, when going either forward or reverse one of the motors starts to rotate about 5 secs before the other motor, and in reverse the same sitution but on the other motors, howcan i adjust the tx to give a situation where the 2 motors start together both in forward and reverse? Do I need to use the curve settings, which i have used previously controlling just one motor and a water jet system. I can see how it might work but i don't have a clue how to do it because of the mix.
Help please!
Thanks
Tony S