JP4IN1 Multi Prot Transm Module OPTION TO DISABLE CHANNEL REMAPPING
Posted: Sat Jul 31, 2021 9:52 am
Hello,
would it be possible to add a "Disabling Channel Re-Mapping" option, selectable at model setup level in one of the next revisions, if any?
As Pascal well pointed out: "You can disable channel re-mapping If you prefer to configure the channel order yourself, or if channel re-mapping is causing problems due to a mismatch between the order in the model and the MULTI-Module's expected channel order".
This useful option would make Er9x even more powerful than it is already.
Thanks!
Regards,
Sergio
would it be possible to add a "Disabling Channel Re-Mapping" option, selectable at model setup level in one of the next revisions, if any?
As Pascal well pointed out: "You can disable channel re-mapping If you prefer to configure the channel order yourself, or if channel re-mapping is causing problems due to a mismatch between the order in the model and the MULTI-Module's expected channel order".
This useful option would make Er9x even more powerful than it is already.
Thanks!
Regards,
Sergio