flashing 9x
Posted: Sun Jul 12, 2020 12:57 pm
hi all
trying to flash a 9x, keep getting the print below is the tx bricked?
=================================================================================
Started AVRDUDE
C:/Program Files (x86)/eePe/avrdude.exe -c usbasp -p m64 -P usb -U flash:w:C:\Users\Tony\Desktop\ER9X\er9x.hex:i
=================================================================================
avrdude.exe: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude.exe: Device signature = 0x1e9602
avrdude.exe: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude.exe: erasing chip
avrdude.exe: reading input file "C:\Users\Tony\Desktop\ER9X\er9x.hex"
avrdude.exe: writing flash (61196 bytes):
Writing | ################################################## | 100% 24.32s
avrdude.exe: 61196 bytes of flash written
avrdude.exe: verifying flash memory against C:\Users\Tony\Desktop\ER9X\er9x.hex:
avrdude.exe: load data flash data from input file C:\Users\Tony\Desktop\ER9X\er9x.hex:
avrdude.exe: input file C:\Users\Tony\Desktop\ER9X\er9x.hex contains 61196 bytes
avrdude.exe: reading on-chip flash data:
Reading | ################################################## | 100% 18.51s
avrdude.exe: verifying ...
avrdude.exe: verification error, first mismatch at byte 0x0034
0x0c != 0x8c
avrdude.exe: verification error; content mismatch
avrdude.exe done. Thank you.
=================================================================================
AVRDUDE done - exit code 1
=================================================================================
if not what do I have to do?
trying to flash a 9x, keep getting the print below is the tx bricked?
=================================================================================
Started AVRDUDE
C:/Program Files (x86)/eePe/avrdude.exe -c usbasp -p m64 -P usb -U flash:w:C:\Users\Tony\Desktop\ER9X\er9x.hex:i
=================================================================================
avrdude.exe: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude.exe: Device signature = 0x1e9602
avrdude.exe: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude.exe: erasing chip
avrdude.exe: reading input file "C:\Users\Tony\Desktop\ER9X\er9x.hex"
avrdude.exe: writing flash (61196 bytes):
Writing | ################################################## | 100% 24.32s
avrdude.exe: 61196 bytes of flash written
avrdude.exe: verifying flash memory against C:\Users\Tony\Desktop\ER9X\er9x.hex:
avrdude.exe: load data flash data from input file C:\Users\Tony\Desktop\ER9X\er9x.hex:
avrdude.exe: input file C:\Users\Tony\Desktop\ER9X\er9x.hex contains 61196 bytes
avrdude.exe: reading on-chip flash data:
Reading | ################################################## | 100% 18.51s
avrdude.exe: verifying ...
avrdude.exe: verification error, first mismatch at byte 0x0034
0x0c != 0x8c
avrdude.exe: verification error; content mismatch
avrdude.exe done. Thank you.
=================================================================================
AVRDUDE done - exit code 1
=================================================================================
if not what do I have to do?