Hey guys,
I have the Horus X12S Opentx. I've been setting up my new IMAC plane and was wondering. When I set my elevator servos in the right direction. The monitor page shows the two channel's being used to control the left and right servos move in opposite directions. Is there a way to get the monitor page to show them moving in same direction as viewed on the tail service if this makes any sense. I basically reversed the weight from positive and negative to reverse the servos on the plane. I've said it before, I'm new to the program side of this raidio so if you have any input I'm all ears.
Thanks
Monitor page.
Re: Monitor page.
No, the channel monitor is meant to show exactly what goes to the servo, not how it's linked to model characteristics. Look at the "mixer" bars if you want to see the "logical" output.
Re: Monitor page.
Ok, that makes sense. Thanks