Page 1 of 1
9x been modded
Posted: Sat Jan 19, 2019 3:43 pm
by Blackdog
Hi any one any idea what's been done to this transmitter
Re: 9x been modded
Posted: Sun Jan 20, 2019 7:06 am
by ShowMaster
Wow what a mess. The white board is a smartipsrts board designed to flash the much processor with upgraded firmware like er9x. It also adds a backlight.
Not sure what the sparkfun board does but maybe it’s fixing a usb connection the smartiparts boars comes with?
This sp board and er9x firmware adds telemetry display the the screen from a Frsky D receiver.
http://smartieparts.com/shop/index.php? ... cts_id=331
The diode and other parts higher on the switch boars was to modify the beeper circuit.
More mods info
https://www.rcgroups.com/forums/showthr ... R9X-OpenTX
https://openrcforums.com/forum/viewforum.php?f=71
The second picture is showing a internal installed Frsky dht solder in module. This 2.4g module supports telemetry from the D receiver to the SP board.
No idea why a external DJT Frsky module wasn’t used unless it left the back case port open for other module options.
Sent from my iPhone using Tapatalk Pro
Re: 9x been modded
Posted: Sun Jan 20, 2019 12:35 pm
by jhsa
I can't see an antenna connected to the module???
João
Sent from my BLN-L21 using Tapatalk
Re: 9x been modded
Posted: Sun Jan 20, 2019 12:54 pm
by bob195558
WOW ! how things have changed in just a few years.
I still have one 9x with Steven's 9x SP 9x Programmer (Rev 2.3)
board and with the 9x TelemetrEZ (Rev 1.0) board.
I have always run the telemetry wires through the back of the radio case
to the FrSky transmitter too.
I have several old un-used SP 9x Programmer boards from
upgrading 9x radios to the 9XTreme boards, which are sold out.
Wish 9XTreme boards were still available.
Re: 9x been modded
Posted: Sun Jan 20, 2019 4:36 pm
by jhsa
bob195558 wrote: ↑Sun Jan 20, 2019 12:54 pm
WOW ! how things have changed in just a few years.
You haven't noticed that?
Since years I have a stock 9x board with a better processor, rotary encoder, more switches, backlight, voice module that also saves models to the SD card, internal DHT module, but I would probably replace it with a MultiProtocol module as it is supported by Er9x, etc, etc.
João
Re: 9x been modded
Posted: Sun Jan 20, 2019 7:06 pm
by bob195558
Re: 9x been modded
Posted: Sun Jan 20, 2019 7:27 pm
by bob195558
- Cold and Snowing today in New England
Update: I have 12 inches of new snow (so far) at 4:30 pm.
Still snowing.
Re: 9x been modded
Posted: Sun Jan 20, 2019 9:11 pm
by MikeB
I think the red, Sparkfun board is a level converter for the telemetry connection to/from the DHT module.
Mike
Re: 9x been modded
Posted: Sun Jan 20, 2019 10:04 pm
by jhsa
Didn't the SP board have the converter already on it?
João
Re: 9x been modded
Posted: Sun Jan 20, 2019 10:44 pm
by bob195558
If I remember correctly, you could do your own upgrade to have Telemetry
or purchase from Steven, his plug and play 9x TelemetrEZ board,
which was much easier to install.
The SP board did the USB Program flashing and the Back Light for the display.
More about the (Rev 2.3: White board. Now includes header and plug/wires for LED connection
and Header for possible future use with TelemetrEZ added.)
Smartieparts.com: (
http://smartieparts.com/shop/index.php? ... cts_id=331).
Discontinued SP Products: (
https://smartieparts.com/shop/index.php ... ex&cPath=9).
Take a trip down memory lane.
(
http://smartieparts.com/shop/)
Some more old 9Xtreme board info here: (
https://openrcforums.com/forum/viewtopi ... =95&t=7182).
Re: 9x been modded
Posted: Sun Apr 12, 2020 5:30 am
by topdiggy2
bob195558 wrote: ↑Sun Jan 20, 2019 12:54 pm
WOW ! how things have changed in just a few years.
I still have one 9x with Steven's 9x SP 9x Programmer (Rev 2.3)
board and with the 9x TelemetrEZ (Rev 1.0) board.
I have always run the telemetry wires through the back of the radio case
to the FrSky transmitter too.
I have several old un-used SP 9x Programmer boards from
upgrading 9x radios to the 9XTreme boards, which are sold out.
Wish 9XTreme boards were still available.
Hello Bill -
Thanks for your post...i recently purchased one of these FlySky FS-TH9x. Im new to RC building my first drone for aerial photo. Anyways, i was wondering if you wanted to sell one of those 9Xtreme boards or program cables.?
Re: 9x been modded
Posted: Sun Apr 12, 2020 10:51 am
by bob195558
See here about 9xtreme boards that are not assembled:
https://openrcforums.com/forum/viewtopi ... 60#p147801
Re: 9x been modded
Posted: Sat Sep 12, 2020 1:44 am
by BiggsDarklighter
topdiggy2 wrote: ↑Sun Apr 12, 2020 5:30 am
Thanks for your post...i recently purchased one of these FlySky FS-TH9x. Im new to RC building my first drone for aerial photo. Anyways, i was wondering if you wanted to sell one of those 9Xtreme boards or program cables.?
topdiggy2 these are the only ones still avalible. If you need ready made, this is where it is at.
https://smartieparts.com/shop/index.php ... e5nhv06665
Re: 9x been modded
Posted: Thu Nov 19, 2020 5:08 pm
by tedbmoss
This is an early Smartie Parts mod to allow reprogramming with out to much soldering. The internal FrSky Tx module has been added or a standard module has been modified and at a guess a further mod has been made to add sound. there was some problems with telemetering which may have been corrected with the Spark-fun board, it is not possible to tell from here , perhaps someone else will know. You should put this in Turnigy 9x instead of th9x it is an obscure place and may not be seen.
I did not see all the other answers when I posted this.