FlySky FS-i6x 433Mhz Mod low range
Posted: Fri Nov 30, 2018 9:12 pm
Hi
Im having a range problem using 433mhz orange HK modules in flysky i6x ?
I have 6+ radios with hawkeye- deluxe,orangetx,orangerx,flytron,
even using a orange Rx as a tx works better
all different radios all work very well
I have fitted orangetx inside my new Flysky radio to PPM trainer port and get low performance beeping at 2-5ks
same module in futaba radio and dont get any beeps to 5 ks
same module in another radio in its fine also
tried two different modules in Flysky radio they all perform low.
I can hear the flysky through my computer speaker is not as powerful
the futaba radio is twice as loud
the deluxe module is 4 times louder again (1 watt)
the ppm voltage on the flysky is 2.75 volts 0.70-0.80ma and 0.45volts 0.2-.04ma on the futaba if that means anything
looks like the futaba ppm signal is inverted as cant see it on my arduino scope
https://youtu.be/f9mzalNyVR0
and that are the two things that are different
this has got me stuffed
regards
Brett
Im having a range problem using 433mhz orange HK modules in flysky i6x ?
I have 6+ radios with hawkeye- deluxe,orangetx,orangerx,flytron,
even using a orange Rx as a tx works better
all different radios all work very well
I have fitted orangetx inside my new Flysky radio to PPM trainer port and get low performance beeping at 2-5ks
same module in futaba radio and dont get any beeps to 5 ks
same module in another radio in its fine also
tried two different modules in Flysky radio they all perform low.
I can hear the flysky through my computer speaker is not as powerful
the futaba radio is twice as loud
the deluxe module is 4 times louder again (1 watt)
the ppm voltage on the flysky is 2.75 volts 0.70-0.80ma and 0.45volts 0.2-.04ma on the futaba if that means anything
looks like the futaba ppm signal is inverted as cant see it on my arduino scope
https://youtu.be/f9mzalNyVR0
and that are the two things that are different
this has got me stuffed
regards
Brett