openrcforums

The lower 0.0-100.0 range does not transmit. While it at the time it is displayed on the X9D version b. On menu 7/12 I changed the delta m/u from 1500 to 1977. I suspect I maybe just tricking throttle to work in the lower range. The problem materialized when I changed out the gimbals to the M-9 version and suspect therein lies the problem. Will I damage anything and should I open the potentiometer. Any advice will be appreciated.

Sent from my Nexus 5 using Tapatalk

You didn't center the throttle stick when requested during calibration.

Kilrah wrote:You didn't center the throttle stick when requested during calibration.

What I mean to say in my second sentence was the graphic display on the X9D actually shows the full range of the throttle function. But it is not reflected in the signal sent to the X8R. Sorry for the confusion.

Sent from my Nexus 5 using Tapatalk

Then you've got a setup problem somewhere and your settings cause it. Could be the end point settings...
You should post your setup.