Speaker holder mod for the pro
Posted: Sun May 27, 2018 8:33 pm
looking a while ago i noticed a mod done by Mnemennth to stimulate the sound that comes out of the 9xr pro. To simplify the installation i decided to print one out and see how it improves on the quality. If you have access to a 3d printer (some libraries have them I have been told) here is what it could look like for you.
Finally the stl
It takes about 20 min to print and uses very little material. This holder is designed for drop in and hot glue application, you could probably just use foam to immobilize the fit if you wish not to glue but you still have to cut out the small square stand-off at the top of the radio with some fine wire cutters. I used the original speaker for the job - just remove the oem speaker holder from the radio (screws). The sound is definitely louder and has more base to it.Finally the stl