What Firmware for 9xr w/multiprotocol
Posted: Sat Apr 29, 2017 12:48 am
I have a 9xr with the Irangex IRX-4 multiprotocol module. I'm trying to figure out which firmware to install that will allow selection of the protocols on the module.
I looked at OpenTX, but in the OTC Companion app it doesn't list Multimodule as an option for the 9XR/m128. It is there for a few other radios including the 9x w/AR9x chip.
So, it looks like ER9X would have the multimodule support, but which version do I use. I found a bunch of .hex downloads in the "er9x testing" thread. Once I have a .hex file that will do the trick, how do I actually flash it? I installed eePe, but it doesn't look like there is any way to flash a .hex file to the radio through the software.
I'm sure I'm missing something. Thank you in advance for any help in navigating this.
Jerry
I looked at OpenTX, but in the OTC Companion app it doesn't list Multimodule as an option for the 9XR/m128. It is there for a few other radios including the 9x w/AR9x chip.
So, it looks like ER9X would have the multimodule support, but which version do I use. I found a bunch of .hex downloads in the "er9x testing" thread. Once I have a .hex file that will do the trick, how do I actually flash it? I installed eePe, but it doesn't look like there is any way to flash a .hex file to the radio through the software.
I'm sure I'm missing something. Thank you in advance for any help in navigating this.
Jerry