More Channels on the 9x
-
- Posts: 3
- Joined: Wed Jul 16, 2014 12:50 pm
- Country: -
More Channels on the 9x
I have seen in a few places people talking about putting more channels on the 9x but I didn't see any results. Has anyone actually achieve to add more channels to the 9x and if yes how was it done (simple language please)
-
- Posts: 3
- Joined: Wed Jul 16, 2014 12:50 pm
- Country: -
Re: More Channels on the 9x
And I forgot to mention I want to use the frsky module so I can have telemantary is it possible with it or do I have to get dsm2/dsmx module
- MikeB
- 9x Developer
- Posts: 17996
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: More Channels on the 9x
Several ways, if you are using er9x.
1. Choose PPM16. This puts 8 channels on the main module and 8 more channels on the trainer output. Add a DHT module on the trainer signal.
2. Use a Frsky XJT. This will accept up to 12 channels in PPM.
3. Use a XJT, but select PXX as the protocol. This will give 16 channels.
For telemetry, you will need to do the hardware mod(s) to make it accessible,.
Mike.
1. Choose PPM16. This puts 8 channels on the main module and 8 more channels on the trainer output. Add a DHT module on the trainer signal.
2. Use a Frsky XJT. This will accept up to 12 channels in PPM.
3. Use a XJT, but select PXX as the protocol. This will give 16 channels.
For telemetry, you will need to do the hardware mod(s) to make it accessible,.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 3
- Joined: Wed Jul 16, 2014 12:50 pm
- Country: -
Re: More Channels on the 9x
Thanks for the reply. I would probably do the first option because it's cheaper and I don't have to get it all at once.(at moment I just need 8ch but later I may need more)
I would like to know about what receivers would be compatible and how would the receivers be setup 2 separate receivers or connected through s.bus
Edit will the telemantary just come from the the reciver bound to the diy module so I only need to mod just like in http://www.rchacker.com/projects/turnig ... -telemetry and then add dht module to trainer port(any picture on how to do it)
I would like to know about what receivers would be compatible and how would the receivers be setup 2 separate receivers or connected through s.bus
Edit will the telemantary just come from the the reciver bound to the diy module so I only need to mod just like in http://www.rchacker.com/projects/turnig ... -telemetry and then add dht module to trainer port(any picture on how to do it)