Hy,
have a Taranis, a th9x and a 9XR
all have the latest software now 2923
measering PPM output with a oszi at th9x and 9XR as student
and look at Servomonitor Taranis as Teacher ch1 to ch 8 with source PPM1 to PPM8
connected with 3,5mm Mono
First test:
th9x connected to Taranis
1. power off Protokoll PPM or PPM16 8Ch 22,5m 300us positiv, PPM output is ok at oszi and at Taranis ch 1 to ch8 PPM1 to PPM8
2. power on Protokoll PPMsim 8 ch 22,5ms 300us positiv, PPM output is ok at oszi and at Taranis ch1 to ch8 PPM1 to PPM8
Second test:
9XR connected to Taranis
1. Power off Protokoll PPM 8ch 22,5ms 300us positiv -->No PPM output !! nothing!!
2. Power off Protokoll PPM16 8ch 22,5ms 300us positiv -->PPM output at oszi but nothing at Taranis ??ch9-16 at jacket??
3. Power on Protokoll PPMsim 8ch 22,5ms 300us positiv -->only here PPM output at ozi and at Taranis ok ch1 to ch8 PPM1 to PPM8
No my Question?
Is this correct at 9XR this different Funktions with same software?
or is this depending at minimal hardware differenz th9x and 9XR
Hellle
9XR PPMout test with oszi and Taranis ?????
9XR PPMout test with oszi and Taranis ?????
Last edited by Helle on Sat Jan 11, 2014 12:16 pm, edited 1 time in total.
Re: 9XR PPMout test with oszi and Taranis ?????
HK have done a mess with the 9XR with their 2 trainer ports. Then they have changed it again after a few months, so there are 2 different versions in this regard.
I don't think anybody really had access to both versions and was bothered enough to look closely at how to support them optimally, so the code is just the same as on the 9x and it does whatever it does on each of them
I don't think anybody really had access to both versions and was bothered enough to look closely at how to support them optimally, so the code is just the same as on the 9x and it does whatever it does on each of them
Re: 9XR PPMout test with oszi and Taranis ?????
Hy kilrah,
ok, I see, typical HK with stupidity
Helle
ok, I see, typical HK with stupidity
Helle