Hi,
Is it possible on the Taranis 9XD plus to set up Expo on the elevator so that UP elevator is say 25% & down is set at 12% on one switch?
Many Thanks
Ian
Expo on Elevator
Re: Expo on Elevator
Only by making a custom curve, but companion has a curve generator that will help.
- MikeB
- 9x Developer
- Posts: 17996
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Expo on Elevator
Yes with erskyTx firmware, you may set the amount of expo differently on either side of centre, and you have three possible pairs of settings.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!