Hello All,
I thought I was getting fairly proficient at basic model set up but...
Attached is an eepe for my Fun Cub. In addition to 2 Ail, 1 Elev, Thr, 1 Rud and 2 Flap Servos on a Y cord) servo operation with high and low rates, I added a mix for some slight down elevator with increasing throttle, and a mix for slight down Elev with half flap and a bit more with full flap.
Issues are that when checking function on the servo screen Elev does not work at all when switched to low rates but Ail and Rud do and the programming looks the same to me.
And, the down Elev mix with Thr and Flaps on the servo screen does not work either.
It would be appreciated if someone could point out my errors.
Thank you, Doc
Help with eepe file please
-
- Posts: 28
- Joined: Mon Jan 26, 2015 4:05 am
- Country: -
Help with eepe file please
- Attachments
-
- 2016-12-4 funcub broken.eepe
- (77.03 KiB) Downloaded 294 times
Re: Help with eepe file please
Can't open your file in eepe or eepskye.. What radio do you have? and what firmware are you using?
João
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Help with eepe file please
It's a 32K hex file so must be from a Taranis. Are you using openTx?
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 28
- Joined: Mon Jan 26, 2015 4:05 am
- Country: -
Re: Help with eepe file please
Oops! My apologies!
It's a Taranis Plus running Open Tx version 2.1.9.
So sorry to leave that out,
Doc
It's a Taranis Plus running Open Tx version 2.1.9.
So sorry to leave that out,
Doc
-
- Posts: 28
- Joined: Mon Jan 26, 2015 4:05 am
- Country: -
Re: Help with eepe file please
I think I found the problem for those having similar challenges - I had mixed the down Elevator with Thr and Flaps in the Inputs page. When I deleted those mixes in the Inputs page and set them up in the Mix page, all went well.
Hope that helps some one else,
Doc
Hope that helps some one else,
Doc
Re: Help with eepe file please
That would make sense since the inputs page does NOT mix anything, it's always only ONE line used at a time per input.